-
Fabrication And Performance Evaluation Of Cold Storage System
-
-
-
The working temperature for evaporator = 80C, the working temperature for condenser coil = 330C
Converting to Kelvin
(ii) Cooling Rate
Plot of temperature against time.
(iii) Physiological weight loss
A weighing balance was used to determine the weight of the stored sample both in the cold room storage condition and in ambient condition for 3 days. The change in weight of the sample was estimated. The percentage weight of the samples was estimated. The percentage weight was estimated using the formula as expressed.
(iv) Colour Changes and Firmness
The changes in colour of the samples were noted both in the cold room storage and in the ambient condition. The physical texture of the samples was examined and noted and the difference in the firmness was also noted after storing the samples in the cold room storage and in ambient condition respectively.
-
-
-
ABSRACT - [ Total Page(s): 1 ]ABSTRACTSA portable cold room storage was developed. The system was tested with different types of perishable crops under different temperatures. The system is made up of two units, one,the evaporating unit that is where the produce was stored; it is made up of steel material with 79mm by 45mm in length and breadth. While the second unit is the trolleys, the system consists of a control switch that is calibrated to suit any type of produce stored in the system. It contain a separate basement whi ... Continue reading---
-
ABSRACT - [ Total Page(s): 1 ]ABSTRACTSA portable cold room storage was developed. The system was tested with different types of perishable crops under different temperatures. The system is made up of two units, one,the evaporating unit that is where the produce was stored; it is made up of steel material with 79mm by 45mm in length and breadth. While the second unit is the trolleys, the system consists of a control switch that is calibrated to suit any type of produce stored in the system. It contain a separate basement whi ... Continue reading---