-
The Design And Construction Of 2kva Inverter
CHAPTER ONE -- [Total Page(s) 2]
Page 2 of 2
-
-
-
1.4 SCOPE OF THE PROJECT
The scope of this project based on the design and construction of a 2KVA inverter and its operation, with the output power rating of 2KVA an maximum 7.27A and output voltage of 220V AC sources from a 12v inbuilt battery. This project is basically designed for single phase domestic loads.
1.5 METHODOLOGY
• To study of the previous work on the project so as to improve it efficiency
• Draw a block diagram
• Studying of various components of charge controller and inverter circuit
• Constructs an inverter circuit
1.6 MOTIVATION
With the obvious advantages of the inverter being a cheaper [in the long term] and cleaner source of energy, it is a device that can power essential leads. In the absence of supply from power supply utilities in the country. Inverter are the best when it comes to back-up since they can come up very fast and they generate little or no noise unlike generators. Even in an area with constant power supply, power outage due to natural cause and fault are usually unannounced. It therefore very important to prevent causality and loss of good will by having a reliable back-up power installed (OYETUNJITOBI,S. (2015), construction of 2KVA inverter Electrical/Electronic Engineering Project Power Option HND II Final Year Unpublished).
1.7 LIMITATION OF THE PROJECT
The major limitation of this project is that it cannot operate equipment or an electronic device that is above its rated current.
• Also the used of bulky transformer instead of copper transformer which is lighter and smaller in size but more expensive is another limitation.
CHAPTER ONE -- [Total Page(s) 2]
Page 2 of 2
-
-
ABSRACT - [ Total Page(s): 1 ]ABSTRACTThis project presents the design and construction of a DC to AC inverter system. It is designed to meet up with the power demand in the offices/homes in the absence of power supply from National Supply Authority.It is designed in such a way that it will take up to 12V DC from battery and inverts it to an output of 220V, 50Hz AC. It makes no noise during operation and not hazardous like carbon monoxide is generated to the surrounding. This is the feature makes it safe to used anywhere whe ... Continue reading---
TABLE OF CONTENTS - [ Total Page(s): 2 ]TABLE OF CONTENTTITLE PAGE CERTIFICATION DEDICATION ACKNOWLEDGMENTABSTRACT TABLE OF CONTENT CHAPTER ONEINTRODUCTION1.1 BACKGROUND OF THE STUDY 1.2 PROBLEM OF STATEMENT 1.3 AIM AND OBJECTIVE1.4 SCOPE OF THE PROJECT 1.5 METHODOLOGY1.6 MOTIVATION 1.7 LIMITATION OF THE PROJECTCHAPTER TWOLITERATURE REVIEW2.0 INVERTER 2.1 HISTORY OF INVERTER2.2.1 GENERAL FEATURES OF THE PROTECT2.2.1 POWER SUPPLY UNIT2.2.2 CHANGENG OVER UNIT 2.2.3 SWITCHING UNIT2.2.4 UNDER AND OV ... Continue reading---
CHAPTER TWO - [ Total Page(s): 2 ]CHAPTER TWOLITERATURE REVIEW2.0 INVERTER An enabling technology, power electronics does it job with intelligence, precision and efficiency. It used the smartness of advanced control technology with the efficient conversion of electric power into the precise from required to control a function or process. In a industrial and commercial products, it is gaining ground mostly visible among inverters which converts direct current (DC) into a single or poly phase AC voltage at a desire aptitu ... Continue reading---
CHAPTER THREE - [ Total Page(s): 9 ]The capacitance is thus, the number of coulumbs stored per unit voltage across the capacitor i.e.C= Where C is the capacitance in farads Q is the charge in coulumb V is the voltage across the capacitor in voltsFig 3..2 capacitor 3.1.3 DIODE A diode is a semi-conductor device which allow flowing of current in one direction. Diode is a device which can be either forward or reversed biased. It has a low resistance and is unidirectional. Diodes are va ... Continue reading---
CHAPTER FOUR - [ Total Page(s): 5 ]Ns = 3520/12=293 turnsTherefore Es = 240vNs/Np = Es/EpNs = (Np Es)/EpNs = 240 x 16 12Ns = 3840 = 320 turns 124.1.3 FREQUENCY DIVISION COUNTER This unit is made up of integrated circuit, it serve as a counter to divide the 100Hz signal generated into two equal part i.e 50Hz (Nigeria Standard), these divided frequency of 50Hz each is in the anti-phase and therefore are each alternating fed to the base of the MOSFET in the inverting stage.4.1.4 FREQUENCY UNIT The purpose of this proj ... Continue reading---
CHAPTER FIVE - [ Total Page(s): 1 ]CHAPTER FIVECONCLUSION AND RECOMMENDATION 5.1 CONCLUSIONThe basic objective of the project that were realized include the guarantee of the supply during the absence power from service authority, the elimination of power surges and energy management induction of bill amazed from fuel cost and generator maintenance. The inverter is more environmentally friendly, easier to operate and required very little maintenance compared to a generator.Through the project is efficient and reliable, it has so ... Continue reading---
REFRENCES - [ Total Page(s): 1 ]REFERENCESBEDOFORD,B.D, et al. Principle of inverter circuit New York, John Willey, (1964). David L.A. Modern UPS Servicing, Marc Dowell publishers, London, (22nd Edition) 2001.Manahar Lofia, Modern Digital Inverter-Introduction Servicing and Troubleshooting, (23rd edition)1996.OYETUNJI TOBI,S. (2015), construction of 2KVA inverter Electrical/Electronic Engineering Project Power Option HND II Finial Year, Unpublished.Tharaja B.L et al, A Textbook of Electrical Technology, S. Chand & Company Lt ... Continue reading---
