-
Design And Construction Of A Single Phase Auto Transformer Of Rating Ikva 240v/110 80 12v 6v
CHAPTER ONE -- [Total Page(s) 3]
Page 3 of 3
-
-
-
Primary
Winding: The primary winding of a transformer is the winding that is
directly connected to the over is the winding that is directly connected
to the supply.
Secondary Winding: This is the winding that is directly connected to the head.
Tappings:
Tappings refers to the connections which are usually made successively
in the winding of a transformer especially in auto transformer.
Step up: When the primary voltage is lower than the secondary voltage, the transformer is caved a step up transformer.
Step down: When the primary voltage is higher than the secondary voltage, the transformer is called a step down transformer.
Window: This is the space in the transformer core bounded by the 10Kes and the timbs of the transformer.
Varnish:
This is an insulating Tigard which used to increase the insulation of
the transformer core and winding as well as making it inechanically
strong. It so laxities when air acts and it.
Copper Conductors: These are bare copper worse which are used in transformer windings.
Wire Sleeve: This can be fibre or plastic coating which is used to insulate and isolate the transformer winding terminals.
Slot
Popper: This is a thick insulating paper which is used to wrap the
transformer winding and separate each layer of the winding. It serves as
mechanical protection.
Center Block: This is a wirden block
approximately the size of the central limb of the transformer core. It
is on the centre block that the former is made.
CHAPTER ONE -- [Total Page(s) 3]
Page 3 of 3
-
-
ABSRACT - [ Total Page(s): 1 ]This project work-up deals on the design and construction of a single phase step down nations fermor, with raking IKVA, 240V/11OV, 80V 12U, 6V. It is a multi-circuit transformer that has one input as the primary and tappins to produce the output (secondary). It is considered as a single coil in series with the supply and a common coil to the head. It is experimentally done using flat metal shocks of cast steel to form the “E†and “I†shaped laminations and coils of variou ... Continue reading---
