-
Design And Construction Of A Central Wireless Switch That Controls The Entire Appliances
CHAPTER ONE -- [Total Page(s) 3]
Page 2 of 3
-
-
-
1.3 Aim and Objectives
This
project focuses on design and construction of a central wireless switch
that controls the entire appliances for electrical and electronic
engineering general office. Therefore, the specific objectives are as
follows;
1. To design a device that controls electrical and electronic appliances.
2. To provide a wireless system that can switch off and on electrical and electronic appliances
3.
To design and construct a system that uses GSM network for control of
the entire appliances for electrical and electronic engineering general
office
1.4 Scopes of Work
The central wireless switch for
electrical and electronic appliances project uses GSM network to cover a
wide area of operation but it is limited to network failure and airtime
subscription.
1.5 Major Constraints
Along the course of project completion we encountered various problems
and
obstacles. Not everything that we had planned went smoothly during the
project development span. Also we had a limited amount of time for its
completion
so we were under a certain amount of pressure as well. We had to start
from the research phase at the beginning and needed to gain knowledge on
all the devices and components that we had intended to use for our
project. Other phases of the project included coding, debugging,
testing, documentation and implementation and it needed certain time for
completion so we really had to manage the limited time available to us
and work accordingly to finish the project within the schedule. One of
the major constraints of this project is the funding and sourcing of
some components like the signal transistors and microcontroller chip
used.
CHAPTER ONE -- [Total Page(s) 3]
Page 2 of 3
-
-
ABSRACT - [ Total Page(s): 1 ]The purpose of this project is to design and construction of a central wireless switch for electrical and electronic appliances. A central wireless switch for electrical and electronic appliance is a GSM based online power control switch system that controls the entire appliance in the EEE general office using GSM network. It will act as an embedded system which would monitor and control appliances and other devices locally using built-in input and output peripherals. This device can control the ... Continue reading---
