-
Design And Construction Of Rf Based Remote Controller For Electric Lamp
CHAPTER ONE -- [Total Page(s) 2]
Page 2 of 2
-
-
-
1.4 SIGNIFICANCE OF THE PROJECT
This project work
signifies a lot in telecom, computer and electronic engineering. It is
very useful in a number of domestic places like in bedroom and security
lamps in the compound. A project of this type if modified can be used as
a gate/door opening system, car immobilizer and for industrial process
control. Another vital significance of this system is in the control of
Air conditioner and refrigerators and other lamps in modern buildings.
This system can be used to start and stop a power generating set from a
distance.
1.5 SCOPE OF THE PROJECT
This project work covers the
following: tuned radio frequency transmitter and receiver, flip-flops,
Darlington pair transistors and delay circuits. It also lays great
emphasis on passive and active components used to implement the system.
It x-rays the mode of calculation of the basic circuit parameters and
other areas of application of the system.
1.6 PROJECT REPORT ORGANIZATION
This
project is presented in six chapters to appropriately illustrate the
steps involved in its implementation. Chapter one introduce the design
overview, objective and significance of the project. Chapter two is
basically the literature review and some theories relevant to the
design. Chapter three x-rays the methodology and analysis. Chapter four
is on the system design analysis while chapter five elaborates on the
implementation, testing and results. Finally chapter six summarizes the
entire thesis and recommendations.
CHAPTER ONE -- [Total Page(s) 2]
Page 2 of 2
-
-
ABSRACT - [ Total Page(s): 1 ]This project work deals on the design and construction of an Rf based remote control for an electronic/electrical device say electric lamp with the aim of switching on/off of the lamp at discretion and from a distance. It also eliminates the inconveniences associated with manual switching of lamps. This electronic system is designed in two functional units; the transmitter and the receiver using radio frequency (RF) communication wave band. The transmitter is a hand-held remote control while ... Continue reading---
