-
The Design And Fabrication Of A Metal Bookshelf
-
-
-
Knowledge could only be obtained successfully by the use of book for research but unfortunately because of hard times, books have become very expensive. This is called for presentation of books already purchased whether in the library or on the household so that it can be used by the future generation. There could only be done by stacking books systematically on a book rack where by it can be file from rats and other insects that could blestroy books.
Our aim contribution to this development is the design and manufacture of a book rack that will be economically cheap and at the same time meet up its demands.
Book racks could be made with metals or wood. Again they could be attacked to the wall or they could be made standby on the floor. Our book rack will be of metal and made to stand on the floor.
-
-
-
CHAPTER ONE - [ Total Page(s): 2 ]THE BACK
The back of the book shelf is shown in the figure provided (fig2). It
is made up of the same metallic mild steel used for the side, it is
welded to the square pipe frame and 6the sides at angle of 90o. its
measurement is 1200mm. With a thicken of 3mm.
Since the back serves as a cover sort of to the system, a metallic
sheet with a higher this chime in chosen so as to withstand rush,
corrosion, inte ... Continue reading---
-
CHAPTER ONE - [ Total Page(s): 2 ]THE BACK
The back of the book shelf is shown in the figure provided (fig2). It
is made up of the same metallic mild steel used for the side, it is
welded to the square pipe frame and 6the sides at angle of 90o. its
measurement is 1200mm. With a thicken of 3mm.
Since the back serves as a cover sort of to the system, a metallic
sheet with a higher this chime in chosen so as to withstand rush,
corrosion, inte ... Continue reading---
ABSRACT -- [Total Page(s) 1]
Page 1 of 1
ABSRACT -- [Total Page(s) 1]
Page 1 of 1